HUSQVARNA LTH2038
Briggs & Stratton, Hydrostatic, 97 cm / 38 inch
Hp as rated by the engine manufacturer
|
|
|
|
|
|
|
|
|
| Engine | |
| Engine manufacturer | Briggs & Stratton |
| Engine name | Endurance Series |
| Cylinder displacement | 540 cm³ / 33 cu.inch |
| Cylinders | 1 |
| Engine cooling | Air |
| Fuel Type | Gasoline |
| Fuel tank volume | 5.7 lit / 1.5 gal. |
| Fuel tank location | Front |
| Engine lubrication type | Pressure with Oilfilter |
| Oil filter | Y |
| Battery | 12 V 28 Ah |
| Drive system | |
| Transmission type | Hydrostatic |
| Transmission manufacturer | Tuff Torq |
| Speed forward, min-max | 0-8.4 km/h / 0-5.2 mph |
| Speed reverse, min-max | 0-4.7 km/h / 0-2.9 mph |
| Drive Method | Pedal-operated |
| Cutting deck | |
| Blade Type | Hi Performance |
| Cutting width | 97 cm / 38 inch |
| Cutting deck type | Stamped |
| Cutting methods | Side discharge |
| Cutting deck material | Steel |
| Cutting height, min-max | 38 - 102 mm / 1.5 - 4 inch |
| Cutting height steps | 6 |
| Blade engagement | Manual |
| Blades | 2 |
| Anti-scalp wheels | 0 |
| Powder-coated cutting deck | Y |
| Deck Wash Port | Y |
| Cutting Heigh Adjustment | Notch |
| Cutting Height Adjuster | Fender-mounted |
| Other | |
| Seat material | Vinyl |
| Seat back height | Medium |
| Hour meter | Digital with pre-programmed service intervals |
| Cup holder | Y |
| Steering wheel type | Ergonomic |
| Step-through chassis | Y |
| Cast iron front axle | Y |
| Pivoting front axle | Y |
| Front-End Protection | Tube Bumper |
| Headlights | Y |
| Collector | Available as accessory |
| BioClip® kit/plate | Available as accessory |
| Dimensions | |
| Tyre size, front | 15x6-6" |
| Tyre size, rear | 20x10-8" |
| Base machine, width (chute down) | 126 cm / 49.75 inch |
| Base machine, width (chute up) | 104 cm / 40.75 inch |
| Turning Radius Min | 41 cm / 16 " |
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:


TrioClip
Pedal-operated hydrostatic transmission
Year-round use
Step-through
Fender-mounted cutting height adjustment